So I finally got around to finishing my peg board, I’ve been posting photos of the progress for long enough on facebook. This is a continuation of my rockclimbing wall/hang board, using the pieces of plywood from that project. I first saw a peg board in action in a video by Jim Bathurst from beast skills, it looked really cool and I filed it in the back for my brain for when I had the plywood and time. And when I got given the two sheets of ply I knew what I wanted to build. I made lots of mistakes on this project which is why it’s taken so long and I’ll outline all of them that I can remember so that you don’t have to repeat my mistakes.
I started with two pieces of ply, 400mm by 2400mm (I cut
these from a full sheet of ply costing about $80NZ yielding 3 strips). I glued
these together with ‘no more nails’ wood glue and let the glue set under the
weight of my sandbags and kettlebells (Note: I also sourced a piece of 8mm ply
as the backing once all the holes were drilled, this was glued on after
finishing the holes). Next came a series of mistakes.
 |
| Dip bars double as saw horses |
Looking around different sites on the net I found several
people suggested making the holes 30mm and the pegs 28mm, I wanted mine
slightly bigger and tighter so I bought a 32mm auger bit and 32mm dowels. The
problem was that my cordless drill was not strong enough to run the 32mm bit
through the ply straight off so I decided to drill a pilot hole with a 10mm
auger bit. The holes were drilled 200mm apart, one line in the centre then 80mm
up from the bottom and down from the top.
The problem came then I tried to drill through the pilot
hole with the 32mm drill bit. Since it has a small cone shaped tip to start the
hole the large section of the bit moved around a lot before finally biting in and
getting going, this made a mess on the board (really it wasn’t so bad but I’m
picky). Also once the bit broke through to the other side it made a mess of the
other side to (again I’m just picky). So I did my best to keep it looking good
by drilling from both sides which didn’t quite line up exactly. So following
this I had to clean up the holes with some drill bits used kind of like a dremmel
to shape things, I don’t know what they are called but it took ages.
 |
| You can see how the holes are a bit rough |
Once all the drilling was done, which took a long time
since my cordless drill could only manage 5 holes before running out of power,
I could test out dowel I bought, it was too small. The dowel moved around too
much from my liking so I took it back and swapped for the next size up, 35mm,
which was too big. At this point I put the pegs in the “later” basket; I glued
the 8mm ply to the back, and mounted the board on the wall in my garage. First
the two 2x4s were screwed to the wall, then the board on top of that, it’s
super strong and feels totally safe. Finally, I cut 4 pegs at 200mm each (from
the 35mm dowel) and sanded down the ends to fit into the board. I like to have
spares which is why I cut two extra.
 |
| Two pegs the the ends sanded down to fit |
It feels great to have the board finally finished. It’s
really hard and fun to use and will be great for training for the one arm chin
ups. This project probably took 20 hours or so, due to all my mistakes. I
suggest buying or borrowing a powerful drill; it will make everything so much
easier. I’m happy with how it’s turned out. I would probably do it again,
however I can always take it down and bring it with me if I move, maybe in the next
garage I might have the height to mount it vertically, or at least on an angle.
